SCIENTIFIC HUB

Follow the evidence.

SCIENTIFIC LITERATURE · MED

A passive T/V-beam absorber architecture for single-axis experimental hand tremor attenuation.

Med Eng Phys · 2026-06-03

DOI: 10.1088/1873-4030/ae7112PMID: 42167291

Check source for accessJournal ArticleOriginal source ↗

Research overview

The text below is the source article’s original abstract under a verified reuse license. cc by

Hand tremor is a debilitating motor symptom associated with neurological disorders such as Parkinson's disease and essential tremor (ET). This study presents the design, parameter tuning, and experimental evaluation of a passive mechanical absorber for tremor attenuation based on T- and V-beam configurations. The proposed device is described as an multi-degree-of-freedom-capable architecture because its geometry can accommodate absorber branches oriented in more than one direction; however, the present experimental validation was conducted using a single-axis, 1-DOF mannequin-based tremor simulator. Therefore, the reported data validate single-axis attenuation only and should not be interpreted as full multidirectional wrist validation. The system operates without external power and is intended as a simple passive alternative to active tremor-suppression devices. Experimental validation demonstrated a reduction of up to 85% in steady-state peak-to-peak displacement relative to the uncontrolled condition. The investigated frequency range was 3.0-6.5 Hz, selected because it overlaps the 4-6 Hz range often reported for Parkinsonian rest tremor and extends into the lower-to-mid range commonly observed in ET during postural or kinetic tasks. Key design parameters, including absorber mass, equivalent stiffness, beam-position geometry, and actuator configuration, were selected using a constrained parametric tuning procedure rather than an unconstrained global optimization. Frequency-domain metrics, including power spectral density and transmissibility, are defined to complement the time-domain amplitude-reduction metric and to verify attenuation at the dominant excitation frequency. The results suggest that the double V-beam configuration provides stronger single-axis attenuation than the single-actuator configuration and supports further development toward wearable tremor-management applications.

Scientific assessment

01

Research question

Assess the question within the original study’s scope.

02

Methods & sample

Check the source article for study design and sample details.

03

Key findings

An editorially approved findings summary is not yet published for this record.

04

Limitations

Generalizability, bias and clinical meaning require separate assessment.

Methods, samples and clinical conclusions are not inferred from bibliographic metadata.